The installation height of cable tray can be adjusted within 2.2-2.8m. When 2.2m is selected, artificial demolition and destruction shall be prevented. When selecting 2.8m, pay attention to other items such as ventilation ducts that affect the visual field of the video detector.

支架距車位線的水平距離可在3-4米范圍內調整，雙車位可選擇車行道中間位置(寬度)。該安裝支架應為場地起重設備的較低的安裝位置。在有坡度的地方安裝安裝支架時，安裝支架的坡度應與建筑物的坡度一致。在有圓弧的建筑物上安裝支架時，圓弧應一致。

The horizontal distance between the bracket and the parking line can be adjusted within 3-4 meters, and the middle position (width) of the roadway can be selected for double parking spaces. The installation bracket shall be the lower installation position of the site lifting equipment. When installing the support at the place with gradient, the gradient of the support shall be consistent with the gradient of the building. When installing supports on buildings with arcs, the arcs should be consistent.

安裝支架應“水平和垂直”。安裝支架安裝完成后，用水平儀測量安裝支架是否符合水平要求，用激光線投影儀確認安裝支架是否在一條直線上。

The mounting bracket shall be "horizontal and vertical". After the installation of the installation bracket is completed, use a level meter to measure whether the installation bracket meets the horizontal requirements, and use a laser line projector to confirm whether the installation bracket is in a straight line.

設備安裝時，應重新確定安裝支架的高度和水平距離停車位的寬度。氣動球閥安裝選用的支吊架有：雙拉線吊架、單拉線吊架和角鋼支架。

When installing the equipment, the height of the mounting bracket and the width of the horizontal distance from the parking space shall be re determined. The supports and hangers selected for the installation of pneumatic ball valve are: double wire hanger, single wire hanger and angle steel support.

雙拉線吊架由通桿螺釘、拉爆和橫梁組成，每個吊架由兩個通桿螺釘組成。單拉線吊架由拉桿螺釘、拉線和吊架組成，單拉線吊架的每個吊架由拉桿螺釘組成。角鋼支架分為U型支架和L型支架。

The double wire hanger consists of through rod screws, tension blasting and cross beam, and each hanger consists of two through rod screws. The single guy hanger consists of tie rod screws, guy wires and hangers. Each hanger of the single guy hanger consists of tie rod screws. The angle steel support is divided into U-shaped support and L-shaped support.

電纜橋架維修應使用干燥清潔的軟布

Dry and clean soft cloth shall be used for cable tray maintenance

1.日常保養：定期用干凈的軟布擦拭表面的灰塵。

1. Daily maintenance: regularly wipe the dust on the surface with a clean soft cloth.

2.定期保養：用專用的蠟光劑擦拭外部，過一會兒再用干凈的軟布擦亮，使其轉動靈活，防銹抗氧化。通常情況下，一個季度保養一次即可。五金配件、金屬手柄、高溫風扇可以用較少的機油擦拭干燥，防止受潮。軟布擦拭后勾勒出灰塵痕跡。

2. Regular maintenance: Wipe the outside with special wax polish, and then polish it with a clean soft cloth to make it rotate flexibly, rust proof and oxidation resistant. Generally, the maintenance is only required once a quarter. Hardware fittings, metal handles and high-temperature fans can be wiped dry with less oil to prevent moisture. After wiping with a soft cloth, the dust trace is outlined.

3.應使用干凈的軟布，并使用專用保養蠟。

3. Use clean soft cloth and special maintenance wax.

以上就是為大家介紹的有關山東電纜橋架的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://m.zkhtkj.cn

The above is a detailed introduction of Shandong cable tray for you. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with our attitude http://m.zkhtkj.cn